This kit includes the Plug In Watering / Misting Solenoid Valve and the Titan Controls Repeat Cycle Timer which is the control most commonly purchased with this valve. A great combo for misting/watering in seedlings for germination and/or adding humidity to an area.
This unique brass solenoid valve can handle low volume applications like gravity feed and misting systems. All fittings are included to connect the valve to 3/4" threaded PVC or standard 3/4" water faucets/hoses. The solenoid valve also comes wired with an 6' power cord. Plug valve into a humidistat to regulate humidity, plug-in thermostat to regulate temperature, or timer for a variety of watering and misting functions. Requires 110/120 volt outlet. Use with a fine water filter.
Pressure Range: 0 to 140 PSI
Flow Rate: 1200 gph maximum at 65 PSI
Flow Rate: No minimum flow rate for valve
MISTING CYCLE TIMER
This cycle timer is capable of accurately cycling equipment in increments from 5 seconds to 30 minutes of "ON" time and 5 seconds to 60 minutes of "OFF" time between cycles. Timer has a built-in photosensor that cuts the timer off when it gets dark. Photosensor may be switched on or off as desired. It is ideally suited for irrigation, misting, drip, and ventilation controls to name a few. Solenoid valve is needed to automate most misting, drip, and irrigation systems. Timer plugs into a standard 110/120 volt outlet and has an outlet on the front for the device it will control (15 amp max)
- ON time setting range: 5 seconds to 30 minutes
- OFF time setting range: 5 seconds to 60 minutes
- Photosensor allows you to run it during the day, night, or both.
- Operates on 110/120 voltage up to 15 amps
Plug-in Solenoid Valve Instructions
Titan Repeat Cycle Timer Instructions